Traditional Muzzleloading Association

Craftsmanship => Gun Building and Repair => Topic started by: bluelake on July 05, 2009, 07:11:16 PM

Title: Traditions Kentucky Pistol
Post by: bluelake on July 05, 2009, 07:11:16 PM

I'm finally getting around to assembling the pistol kit I got from Buffalo Bill's Shooting Store.  It is a .50 cal. Kentucky pistol from Traditions.  The thing came in a styrofoam box covered with plastic (see pic from their web site) and had no instructions.  I am assuming I put a finish on the entire stock before assembly, but, as a newbie to kit arms, I really don't know for sure; is that correct? (Edit: I found an online pdf that said to put the finish on after it was completely assembled)  Also, what should I use for a finish?  How many coats? (Edit: I found nothing in the pdf about what to use for a finish)

I'm sure I'll have more questions as I proceed.  Thanks in advance!


Thomas


(http://www.buffalobillsshootingstore.com/images/product/870-t.jpg)

Title:
Post by: FG1 on July 05, 2009, 08:34:55 PM

You will want to assemble it first starting with the barrel then the rest of parts to check for fit and function. Take notes before disassembly where and how much wood needs to be removed to slim it down like sides of forearm at muzzle behind cap and grip area to fit your hand and such. Then take it apart and file and sand as needed, raise grain with damp cloth and wait till dry , sand off whiskers with 320-400 paper . Alchohol stains are best in my opinion as they dont raise the grain again. Tru Oil is a good all around finish and is easy to apply .
This is the quick version , I think there is a tutorial in gunbuilding forum .

Title:
Post by: bluelake on July 06, 2009, 12:00:11 AM

Thanks!  

Title:
Post by: pathfinder on July 06, 2009, 06:09:16 AM

If you use an alcohol stain,wet the wood with de-natrured alcohol so you can get an even finish without streakes or blotches. The stock is probably beech is is an unassumung type wood with fairly attractive grain and almost no figure. It will suck up thin stain. I've had no problem with the totally un-p.c. Minwax thinned with the natural stain(clear "stain" no pigment.) I personally like 1/2:1/2 special walnut and red mahogany followed by two thin coats of boiled linseed oil and then full strength. about 8-10 coats should do it. True oil is also good,faster finish just as good.