Craftsmanship > Accoutrements

Long Horn

(1/3) > >>

Spotted Bull:
Any ideas on this monster thang......thought about just putting the fill hole and the dispensing hole both on the big end, and maybe cut a little off the point and make a powder measure.  Then I thought about maybe cutting a little bigger piece off the point and making a priming horn out of that and go ahead and drill out the big piece for a normal horn.




There is about 10 1/2" of hollow in the horn.

mike rumping:
make you a horn drinkin glass, a rum horn and a powder horn, least 14" out'a that one LOL

melsdad:
That would probably make a good horn for blowing, I bet it would be loud.

Trois Castors:
POWDER HORN :rotf

Regards,

Spotted Bull:
any advice on how to NOT screw it up would help as well..........

Navigation

[0] Message Index

[#] Next page