Traditional Firearms > Flintlock Long Guns
Steaming a stock
(1/1)
Winter Hawk:
The new-to-me 3rd T-C Pennsylvania Hunter had a problem: I had to lift my head off the stock to line up the sights. I had thought about putting some type of pad on the comb, but then remembered reading long ago about steaming the stock to alter it. So, I put on a large pan of water to boil, lay the wrist of the stock over it, covered the stock and pan with aluminum foil to seal the steam in, lay a folded towel over top of that and let it sit on the burner for, IIRC, 30 minutes:
[ Invalid Attachment ]
[ Invalid Attachment ]
I then clamped it in my Workmate vice and tightened that down as tight as I could get it:
[ Invalid Attachment ]
and left it overnight. The next day I reassembled the rifle and it formed the stock enough that I can keep a good cheek weld.
A word of caution: I should have put a block between the vice jaws and the the stock at the tang. It broke a small piece of wood off the inlet for the tang. I didn't notice that until I was putting it together again, and by that time the sliver had disappeared in my garage/shop.
Otherwise this worked well for me.
~Kees~
PetahW:
.
Not for the faint of heart - nice work ! :toast
Hank in WV:
Did it affect the finish at all? I've steamed raw wood before, but never finished wood.
Winter Hawk:
--- Quote from: Hank in WV on April 02, 2024, 05:42:06 PM ---Did it affect the finish at all? I've steamed raw wood before, but never finished wood.
--- End quote ---
Yes it did. The portion which was over the pot is noticeably darker than the rest, sort of like it got a sun tan with the ends covered. But it doesn't look bad so I'm leaving it as is.
~Kees~
Navigation
[0] Message Index
Go to full version