Your TMA Officers and Board of Directors
Support the TMA! ~ Traditional Muzzleloaders ~ The TMA is here for YOU!
*** JOIN in on the TMA 2024 POSTAL MATCH *** it's FREE for ALL !

For TMA related products, please check out the new TMA Store !

The Flintlock Paper

*** Folk Firearms Collective Videos ***



Author Topic: Sight  (Read 650 times)

Offline W. Welshman

  • TMA Forum Member
  • ***
  • Posts: 418
    • http://www.theweavingwelshman.com/home
  • TMA Member: 321
Sight
« on: May 14, 2010, 07:33:50 PM »
I have a T/C RENEGADE 28 G. barrel what sight should I put on it ? (FRONT ONLY) I'm only shooting shot out of this barrel.
Idaho North TMA State Representative

http://www.theweavingwelshman.com/home

Offline Buzzard

  • TMA Forum Member
  • ***
  • Posts: 208
tc 28
« Reply #1 on: May 15, 2010, 10:35:01 PM »
I'd say, as long as it fits the dovetail and isn't to tall, the shorter the better, imho, just pic any one you like! I'm assuming an octagon barrel here.
NRA Life
NMLRA Life
TMA Member #258
Ohio State Trappers Life
Longhunter Measurer

Expires 04/09/2016

Offline huntinguy

  • TMA Forum Member
  • ***
  • Posts: 138
where did you find....
« Reply #2 on: May 18, 2010, 12:39:18 PM »
Where did you find the barrel? I looked on GM web site and they don't have any listed.... I know years back you could get the Renegade from the factory with one... is that what you did?

My Renegade shoots like a shotgun... except you have to load each ball and aim at the same spot... It is a good pattern for a scatter gun though  :evil:
Anything worth shooting is worth shooting once.

Offline W. Welshman

  • TMA Forum Member
  • ***
  • Posts: 418
    • http://www.theweavingwelshman.com/home
  • TMA Member: 321
(No subject)
« Reply #3 on: May 18, 2010, 01:00:32 PM »
My brother had the barrel laying around the house, he took it over to Mr. Taylor to have it bore out. I'm going to re-finish the barrel and replace the sights on it.
Idaho North TMA State Representative

http://www.theweavingwelshman.com/home