Traditional Muzzleloading Association
Craftsmanship => Gun Building and Repair => Topic started by: huntsman247 on November 29, 2009, 12:55:15 AM
-
Hi everyone, new here. What I am looking for is someone to rebore my T/C .54 with the QLA muzzle. Would like to rebore to a .58 slow twist for RB. Any suggestions or comments? Thanks
-
Hi everyone, new here. What I am looking for is someone to rebore my T/C .54 with the QLA muzzle. Would like to rebore to a .58 slow twist for RB. Any suggestions or comments? Thanks
It might be a good idea to do some homework as to cost to rebore and rerifle versus buying a new barrel and having a drop in made up.
What I've read about and seen is simply cutting the T-C barrel behind the QLA and recrowning.
Someone will be along shortly with differing opinions and suggestions.
Good luck with whatever you decide to do.
Three Hawks
-
If you have a 1" barrel you should be able to do it. If the barrel is 15/16" it would probably be too thin to be safe.
As Three Hawks said you also should look at the price of just getting a new barrel. Having a barrel rebored and rifled usually costs about twice what a new barrel would cost.
-
It is the 1" barrel, from what I have found so far it is around $150.00 to have rebored; although that seems pretty low. I would have liked to go with a GM barrel but seems they are few and far between these days. Besides, I would like to put the factory barrel to use as I did purchase the GM .54 barrel for the T/C several years ago; great barrel!!
-
Got one rifle with the "QLA".
The onlyest problem with the set-up appears to be that the entrance into the rifling (at the bottom of the counterbore) is SQUARE CUT.
Now how in blue blazes are you supposed to get down in there to redo that angle and make a cone entrance? Yeah, very carefully.
Maybe if I fire a brazilion or so ticking patches with Clover valve grinding compound the problem will fix itself.
Rebore to a .577 bore may be in the cards. Maybe make it just fast enough to still stalize minies...about a five foot twist? That oughta work with RB?
-
Being the barrel is not an item thhat has no sentimental value . I would agree with others here and buy a drop-in. You could have QLA barrel reamed to .56 cal. and have a neat little smooth bore.
-
Got one rifle with the "QLA".
The onlyest problem with the set-up appears to be that the entrance into the rifling (at the bottom of the counterbore) is SQUARE CUT.
Now how in blue blazes are you supposed to get down in there to redo that angle and make a cone entrance? Yeah, very carefully.
Maybe if I fire a brazilion or so ticking patches with Clover valve grinding compound the problem will fix itself.
Rebore to a .577 bore may be in the cards. Maybe make it just fast enough to still stalize minies...about a five foot twist? That oughta work with RB?
I never understood why TC did not crown the bottom of the QLA .
Its only a small additional step and you tale only seconds in the manufacturing process .
You could do a couple things to crown it
1) a tapered pipe reamer turned slowly by hand
2) a counter sink that is of the QLA bore .
Turned at low speed in a press
Best IMO to just cut the bloody QLA thing off . That way you can do a little file work. cto clean up the flats and re crown . she would then be good as new
-
I have a .50 cal T-C Penn. Hunter that has QLA, and it came crowned. It loads great, shoots great. One can keep all shots in the ten ring at 50yrds. It would do better if I could see better.