Traditional Muzzleloading Association
Shooting Traditional Firearms and Weapons => General Interest => Topic started by: Spotted Bull on March 14, 2013, 11:30:07 PM
-
I was entrusted with the care of a couple of older model CVA rifles. I am told that one was a kit from the 80's and is in pretty nice shape.
The other is, I suppose, in the style of a mountain rifle with the two wedges holding the barrel on, and there are some inlays that look like bone or horn. I will try to get pics if anyone is interested.
What I really want to know is, is there a list of serial numbers that will tell me the date of manufacture for these rifles? I'm just kinda curious...so far I haven't talked the feller out of them!
Also, and I haven't torn it down to take a look-see yet, but the old CVA also has a lock and/or problem. The lock will only hold on half and full cock if the set trigger is pulled first. Can this be easily corrected?
-
The lock will only hold on half and full cock if the set trigger is pulled first. Can this be easily corrected?
Had a similar issue with my CVA Hawken. IIRC, check the sear spring. May need to be replaced.
Mario
-
Also, and I haven't torn it down to take a look-see yet, but the old CVA also has a lock and/or problem. The lock will only hold on half and full cock if the set trigger is pulled first. Can this be easily corrected?
Maybe - Might have to play with the trigger "depth"/tang screw tightness....
-
Also, and I haven't torn it down to take a look-see yet, but the old CVA also has a lock and/or problem. The lock will only hold on half and full cock if the set trigger is pulled first. Can this be easily corrected?
yes and no .
it depends on if you have a hunting style double set or a target style double set .
CVA through the years used both .
if its a target set , then Nope the only thing you can do is replace the trigger set .
if its a hunting double set , then the trigger should allow you to fire the lock no mater if the trigger is set or unset .
easy way to find out is to pull the lock . look into the sear hole while squeezing the front trigger . If you see the trigger bar move up while pulling the front trigger then you have the hunting double set and your problem is most likely that the triggers are inlet to deep . Thus the rear trigger bar will not let the sear engage tell it has been set .
To fix that you need to drop the triggers alittle and some times file the rear trigger bar down so that you can cock the lock . Remember the rear trigger bar cannot touch the sear when cocked , it has to slap the sear