Your TMA Officers and Board of Directors
Support the TMA! ~ Traditional Muzzleloaders ~ The TMA is here for YOU!
*** JOIN in on the TMA 2024 POSTAL MATCH *** it's FREE for ALL !

For TMA related products, please check out the new TMA Store !

The Flintlock Paper

*** Folk Firearms Collective Videos ***



Author Topic: Slowmatch rope  (Read 5073 times)

Offline butterchurn

  • TMA Forum Member
  • ***
  • Posts: 839
Slowmatch rope
« on: April 11, 2010, 10:49:00 PM »
Can Sisal be used for slowmatch or is something else better?
Butterchurn
Member # 249
Exp. 07/12/10

Set your course by the stars, not by the lights of every passing ship.
General Omar N. Bradley

Offline bluelake

  • TMA Forum Member
  • ***
  • Posts: 213
    • http://www.shinmiyangyo.org
  • TMA Member: 424
  • Location: MI
(No subject)
« Reply #1 on: April 12, 2010, 12:50:23 AM »
I'm not familiar with sisal.  Personally, I just buy the "cotton" line from WalMart and pull out the plastic core.  If I could find the right diameter hemp braid, I would try that, as it is more traditional for what Koreans used.  Anyway, I then soak it overnight in a niter/water solution.  The next day, I lay it horizontal and flat on a board (in the sun, if possible).  Mine burns about one inch per five minutes.
Member #424

Offline butterchurn

  • TMA Forum Member
  • ***
  • Posts: 839
(No subject)
« Reply #2 on: April 12, 2010, 01:57:17 PM »
I found some 100% cotton braid sash cord at Menards.  I will give that a go.
Butterchurn
Member # 249
Exp. 07/12/10

Set your course by the stars, not by the lights of every passing ship.
General Omar N. Bradley

Offline bluelake

  • TMA Forum Member
  • ***
  • Posts: 213
    • http://www.shinmiyangyo.org
  • TMA Member: 424
  • Location: MI
(No subject)
« Reply #3 on: April 12, 2010, 05:20:38 PM »
Just make sure it doesn't have a plastic core (IIRC, the WalMart cotton line also said "100% cotton").
Member #424

Offline butterchurn

  • TMA Forum Member
  • ***
  • Posts: 839
(No subject)
« Reply #4 on: April 13, 2010, 12:22:11 PM »
Thanks!  I will check it.
Butterchurn
Member # 249
Exp. 07/12/10

Set your course by the stars, not by the lights of every passing ship.
General Omar N. Bradley

Offline Gambia

  • TMA Forum Member
  • ***
  • Posts: 58
(No subject)
« Reply #5 on: April 13, 2010, 12:33:40 PM »
Would that be the same stuff one would use for in the brass tube fire starters? Where ya' char the end after it is stuck through the brass tube, then flint and steel will get it hot again when you need it, pull it back and it will extinguish.

Offline bluelake

  • TMA Forum Member
  • ***
  • Posts: 213
    • http://www.shinmiyangyo.org
  • TMA Member: 424
  • Location: MI
(No subject)
« Reply #6 on: April 13, 2010, 07:58:34 PM »
Hmmm...  I'm not familiar with that, griz.  Slowmatch burns, well, slowly (well, it also crackles a bit as the niter is burned off).  The more niter the cord is soaked in, the easier it lights (but it also burns faster).  It will go out if it is pinched or stomped, but would be hard to extinguish by cutting off the air supply, as the niter is the oxidizer.
Member #424

Offline Loyalist Dave

  • TMA Forum Member
  • ***
  • Posts: 687
  • TMA Member: 800
  • Location: MD
(No subject)
« Reply #7 on: April 13, 2010, 10:30:04 PM »
Yes it's the same stuff, but match can vary on the amount of KNO3 that is used in the solution.  I have seen people boil it in the solution, and make their own hemp rope and use that too.  I think the boiling helps the cotton rope tighten a bit when drying, and dry faster.

LD
It's not what you think you know; it's what you can prove.

Offline James Kelly

  • TMA Forum Member
  • ***
  • Posts: 94
  • TMA Member: 262
Re: Slowmatch rope
« Reply #8 on: March 22, 2017, 05:40:41 PM »
A while ago I built & shot a matchlock, used Mom's old real cotton clothes line soaked in saltpeter.

Since found this site by a German fellow how to make the real stuff. In short,one boils it in potash. Sounds good to me, my nitrate soaked fuse/match did sputter a bit. BTW as a college freshman I found a real interesting use for the nitrate stuff, but that needn't get on-line.

Slow Match
if the ball is not rammed close on the powder. . .frequently cause the barrel to burst