Your TMA Officers and Board of Directors
Support the TMA! ~ Traditional Muzzleloaders ~ The TMA is here for YOU!
*** JOIN in on the TMA 2024 POSTAL MATCH *** it's FREE for ALL !

For TMA related products, please check out the new TMA Store !

The Flintlock Paper

*** Folk Firearms Collective Videos ***



Author Topic: Pop can mortar loads  (Read 9776 times)

Offline Ironhand

  • TMA Forum Member
  • ***
  • Posts: 242
  • TMA Member: Supporting Member # 664, Expiration 5/4/2019
Pop can mortar loads
« on: March 21, 2023, 05:52:33 PM »
Just acquired this one. Cant find any reference to proper loads. Any suggestions?

Thanks
IronHand
Place your clothes and your weapons where you can find them in the dark.

   Lazarus Long

Offline waksupi

  • TMA Forum Member
  • ***
  • Posts: 116
Re: Pop can mortar loads
« Reply #1 on: March 22, 2023, 10:55:04 AM »
It's been years since I've had one. It doesn't take as much as you would think. If you have an open area to fire it, start with around 90 gr., and go up from there. You can increase the load, watching what the projectile does. It will go from blooping out of the tube, to doing a big launch. No sense using more than necessary.

FYI, if you launch a full beer, they tend to be a bit shook up when you open them!