Your TMA Officers and Board of Directors
Support the TMA! ~ Traditional Muzzleloaders ~ The TMA is here for YOU!
*** JOIN in on the TMA 2024 POSTAL MATCH *** it's FREE for ALL !

For TMA related products, please check out the new TMA Store !

The Flintlock Paper

*** Folk Firearms Collective Videos ***



Author Topic: Happiness is a warm Tung  (Read 6114 times)

Offline Fletcher

  • TMA Forum Member
  • ***
  • Posts: 1511
    • http://www.glaciertraditionalarchery.com
Happiness is a warm Tung
« on: December 26, 2008, 10:32:52 AM »
Christmas Day I got up early yesterday and the rest of the family was still asleep. I thought I would go to the shop and put a Tung oil coat on three bows I had just finished and stained.  It had snowed a bunch (see earlier message) and the shop had cooled down a lot because no one had stoked the fire on Christmas Eve.  The shop temperature was 46 so I lit a fire in the stove and then got out the oil for the bows.  It would not run at all.  I stuck a probe in it and it was thicker than molasses.

So I put the can on the wood stove and started working on another bow roughout.  Got a little involved and forgot the oil for a bit.  When I remembered (getting old you know) I opened the container and poured a little out in a empty tuna can.  I carefully touched it - it was warm, but I had caught it in time.  I would guess 85 to 90 degrees and fortunately not scorched.

Anyway, thought I would just try it that way.  It worked Great!
It coated and absorbed a lot better than it usually did at room temperature (65 to70).  I finished the three bows in no time and when I checked them for dry this morning the finish looks just fine.  I will do another coat tonight and may be able to rub them out on Saturday.

From now on I will warm the Tung oil up a bit.  I think I will use a pot of water for the warm bath on the stove.  I think I came close to scorching it by putting the can directly on the woodstove top - sometimes you get lucky.
« Last Edit: January 05, 2009, 06:10:36 PM by Fletcher »
Fletcher the Arrow Maker
Montana TMA State Representative
TMA Charter Member #143 exp 11/4/18
NRA Training Counselor
BSA National Camp School Director -
Shooting Sports
NRA Life Member
Flathead Valley Muzzleloaders

Offline Longhunter

  • TMA Forum Member
  • ***
  • Posts: 1853
    • http://www.shrewbows.com
  • TMA Member: Charter Member #54 Expires 03/26/2019
(No subject)
« Reply #1 on: December 26, 2008, 11:58:16 AM »
Don't ya love it when you discover something new when ya thought ya knew it all?... :hairy
Ron LaClair
TMA Charter member #54 Valid until 03-26-2019

RON_LACLAIR.html

TMA, Keeping the traditional spirit alive by example

When the deer are gone I will hunt mice, for I am a hunter

Offline Christiaan

  • TMA Forum Member
  • ***
  • Posts: 118
(No subject)
« Reply #2 on: December 26, 2008, 01:16:16 PM »
Give us a pic of the shop please.  It sounds so interesting.
Trust God and keep your powder dry.

Offline Fletcher

  • TMA Forum Member
  • ***
  • Posts: 1511
    • http://www.glaciertraditionalarchery.com
(No subject)
« Reply #3 on: December 26, 2008, 01:23:02 PM »
Pictures eh.....

Do I have to clean it up first???   :oops:
Fletcher the Arrow Maker
Montana TMA State Representative
TMA Charter Member #143 exp 11/4/18
NRA Training Counselor
BSA National Camp School Director -
Shooting Sports
NRA Life Member
Flathead Valley Muzzleloaders

Online BEAVERMAN

  • TMA Contributing Member
  • ***
  • Posts: 6017
  • TMA: TMA Vice President
  • TMA Member: Charter Member #145
  • Location: Vaughn, WA
(No subject)
« Reply #4 on: December 26, 2008, 03:01:40 PM »
Quote from: "Fletcher"
Pictures eh.....

Do I have to clean it up first???   :shock: , why should your shop look any different than anybody elses???????? :lol:  :lol:  :shake
Jim Smith
TMA Vice President
Charter Member #145  EXPIRATION 1/21/25
Green River Mountain Men
Peninsula Longrifles
WSMA
U.S.M.C.
BSA                    
Save America. Spay or neuter a liberal today.

"An armed man is a citizen,..an unarmed man is a subject!"

Offline FG1

  • TMA Contributing Member
  • ***
  • Posts: 1036
(No subject)
« Reply #5 on: December 26, 2008, 03:12:47 PM »
Clean it ........  are ya sposed to clean a shop  :oops:
NRA Life Member

Offline Christiaan

  • TMA Forum Member
  • ***
  • Posts: 118
(No subject)
« Reply #6 on: December 27, 2008, 02:07:33 AM »
Don't clean, otherwise it won't be your shop.

One day when I'm big I would like to have a studio or workshop like this.
http://www.petermain.com/parent.htm
Trust God and keep your powder dry.

Offline Buffler Razz

  • TMA Forum Member
  • ***
  • Posts: 74
(No subject)
« Reply #7 on: December 27, 2008, 08:45:48 PM »
Does opening the door and making a pass with the leaf blower count as cleaning?????
Buffler Razz
aka Ron Razzolini
TMA Member 348
THE TMA "NEEDS" YOU!...JOIN TODAY

Offline Christiaan

  • TMA Forum Member
  • ***
  • Posts: 118
(No subject)
« Reply #8 on: December 28, 2008, 03:43:49 AM »
Only if you blow the leaves away from the door.  :lol:
Trust God and keep your powder dry.

Offline Fletcher

  • TMA Forum Member
  • ***
  • Posts: 1511
    • http://www.glaciertraditionalarchery.com
(No subject)
« Reply #9 on: December 30, 2008, 06:41:42 PM »
As Longhunter seemed to put it - you can learn something new every day.

I suppose you all know the story of the Frog in the Pot:

That is... you put a frog in a pot of hot water, it will jump right out.

Put it in a pot of cool water and slowly raise the tmeperature, it will boil to death just sitting there.  (Scientifically proven!)

Anyway, the moral of the story is... we can have change happen little by little and not see it coming... point in question --->

I was telling about warming up the Tung oil so it would flow better.  Well that really worked, and then I finally ran the can dry.  I bought a new can Sunday and oiled up another bow.  The stuff was nice and thin right out of the store at room temperature!!!

What had happened was........  I have had than can for nearly 4 years (a little goes a long way)  and it was slowly drying and getting thicker just from age and opening the can.  Like the frog, I did not see it coming!

Anyway, it was good to learn that warming up the dregs works also.  I wonder if I will remember this lesson 4 years from now!
Fletcher the Arrow Maker
Montana TMA State Representative
TMA Charter Member #143 exp 11/4/18
NRA Training Counselor
BSA National Camp School Director -
Shooting Sports
NRA Life Member
Flathead Valley Muzzleloaders

Offline R.M.

  • TMA Forum Member
  • ***
  • Posts: 810
  • TMA Member: 134
(No subject)
« Reply #10 on: December 30, 2008, 06:54:09 PM »
Would it be possible to add something like mineral spirits to a thickened oil to stretch it back out?
R.M.
 :Canada
TMA Charter Member #134   Exp. 11/14
Join the TMA. For the money, it's the best BOOM for your 15 bucks.

The tree of liberty must be watered periodically with the blood of tyrants and patriots alike..........Thomas Jefferson

Online Hank in WV

  • TMA Contributing Member
  • ***
  • Posts: 2042
  • TMA Member: Charter Member #65
(No subject)
« Reply #11 on: December 30, 2008, 09:47:49 PM »
Try putting marbles or stones in the can as you use the oil. It keeps air out of the can and helps prolong the life of the oil.
Hank in WV
TMA Charter Member #65, exp 4/30/2026
"Much of the social history of the western world over the past three decades has involved replacing what worked with what sounded good. . ." Thomas Sowell

Offline Fletcher

  • TMA Forum Member
  • ***
  • Posts: 1511
    • http://www.glaciertraditionalarchery.com
(No subject)
« Reply #12 on: December 31, 2008, 10:26:53 AM »
I would be leery of adding spirits, I think it might make it dry faster.

I like the idea of the marbles - but the hole in the lid is rather small.  I think some of my .32 cal lead balls would fit fine.  Do you think lead would be inert to function with the same purpose

Besides, I think I lost my marbles  :oops:
Fletcher the Arrow Maker
Montana TMA State Representative
TMA Charter Member #143 exp 11/4/18
NRA Training Counselor
BSA National Camp School Director -
Shooting Sports
NRA Life Member
Flathead Valley Muzzleloaders

Online Hank in WV

  • TMA Contributing Member
  • ***
  • Posts: 2042
  • TMA Member: Charter Member #65
(No subject)
« Reply #13 on: December 31, 2008, 05:02:56 PM »
Quote from: "Fletcher"
I would be leery of adding spirits, I think it might make it dry faster.

I like the idea of the marbles - but the hole in the lid is rather small.  I think some of my .32 cal lead balls would fit fine.  Do you think lead would be inert to function with the same purpose

Besides, I think I lost my marbles  :lol: I know what you mean about the marbles. I don't see the lead balls  being a problem other than the can will start getting pretty weighty after awhile. Doesn't sound right but, the more you use the heavier it gets.
Hank in WV
TMA Charter Member #65, exp 4/30/2026
"Much of the social history of the western world over the past three decades has involved replacing what worked with what sounded good. . ." Thomas Sowell

Offline Uncle Russ

  • TMA Contributing Member
  • ***
  • Posts: 7339
  • TMA Founder. Walk softly & carry a big Smoothbore!
  • TMA Member: Founder / Charter Member #004
  • Location: Columbia Basin, Washington State
(No subject)
« Reply #14 on: December 31, 2008, 06:36:05 PM »
Now I do like the story about the marbles and the frog.

I would like to hear more about the marbles keeping the air out. Is this done by volume displacement / replacement? Or is there something more mysterious that I am missing in this?

.....wonder where I could find a frog in all this snow?    :?

Uncle Russ...
It's the many things we don't do that totally sets us apart.
TMA Co-Founder / Charter Member# 4