Your TMA Officers and Board of Directors
Support the TMA! ~ Traditional Muzzleloaders ~ The TMA is here for YOU!
*** JOIN in on the TMA 2024 POSTAL MATCH *** it's FREE for ALL !

For TMA related products, please check out the new TMA Store !

The Flintlock Paper

*** Folk Firearms Collective Videos ***



« previous next »
Pages: 1 [2]

Author Topic: What size drill bit?  (Read 1049 times)

Online Hank in WV

  • TMA Contributing Member
  • ***
  • Posts: 1996
  • TMA Member: Charter Member #65
Re: What size drill bit?
« Reply #15 on: December 20, 2011, 05:09:35 PM »
Did you oil the insides of the holes? One time I got lazy and didn't. Well after a couple of hours the block sucked all the lube off the patches and I got a ball stuck half way down the barrel. Didn't get to finish the trail walk that day.
Logged
Hank in WV
TMA Charter Member #65, exp 4/30/2026
"Much of the social history of the western world over the past three decades has involved replacing what worked with what sounded good. . ." Thomas Sowell

Offline jtwodogs

  • TMA Forum Member
  • ***
  • Posts: 90
Re: What size drill bit?
« Reply #16 on: December 21, 2011, 08:37:02 PM »
Yep, laid the 1:1:1 mix to the insides of the holes, wanted that part specailly sealed. They have been hangin in there so far.
Logged
#423 renew 3/14/10
George Washington
" It is impossible to rightly govern the world without God and Bible."
 May 12, 1779
Pages: 1 [2]
« previous next »