Your TMA Officers and Board of Directors
Support the TMA! ~ Traditional Muzzleloaders ~ The TMA is here for YOU!
*** JOIN in on the TMA 2024 POSTAL MATCH *** it's FREE for ALL !

For TMA related products, please check out the new TMA Store !

The Flintlock Paper

*** Folk Firearms Collective Videos ***



« previous next »
Pages: [1]

Author Topic: Silver Bend!  (Read 963 times)

Offline SAWMA

  • TMA Forum Member
  • ***
  • Posts: 275
Silver Bend!
« on: March 02, 2009, 01:28:15 PM »
I have some silver that i would like to bend. Some say to heat the piece then plunge it red hot into cold water to soften the silver before correcting the bend. Has anyone done this, or can it just be hammered when hot?  

Any assistance would be appreciated, thanks!
Logged
SAWMA

Every Animal Knows More Than You Do!
TMA #193
5/16/14

Offline Indiana

  • TMA Forum Member
  • ***
  • Posts: 560
(No subject)
« Reply #1 on: March 02, 2009, 02:25:12 PM »
Once you anneal it (heat and cool) it should be pretty easy to bend once cool.  I don't think there is any need to keep it hot while bending, I think that'd just be more trouble than you need.  Once it has been annealed, it should bend just fine for you.
Logged
"Damn the sword! When Virginia wanted a sword, I gave her one. Now she sends me a toy when I require bread!” -George Rogers Clark

Offline LRB

  • TMA Forum Member
  • ***
  • Posts: 137
(No subject)
« Reply #2 on: March 02, 2009, 05:56:07 PM »
No, don't plunge into water immediately. Let it air cool for a few minutes then you can put it in water. You really don't have to put it in water at all. Just get it red hot, and let it cool. I have had it become brittle from quenching in water at red hot. May have been a bad batch of silver, but it was an expensive lesson.
Logged

Offline SAWMA

  • TMA Forum Member
  • ***
  • Posts: 275
(No subject)
« Reply #3 on: March 03, 2009, 08:22:57 AM »
Will not use the water, thanks guys!
Logged
SAWMA

Every Animal Knows More Than You Do!
TMA #193
5/16/14
Pages: [1]
« previous next »