Your TMA Officers and Board of Directors
Support the TMA! ~ Traditional Muzzleloaders ~ The TMA is here for YOU!
*** JOIN in on the TMA 2024 POSTAL MATCH *** it's FREE for ALL !

For TMA related products, please check out the new TMA Store !

The Flintlock Paper

*** Folk Firearms Collective Videos ***



« previous next »
Pages: 1 [2]

Author Topic: Ante-Chamber on a T/C Rifle.  (Read 1846 times)

Online Hank in WV

  • TMA Contributing Member
  • ***
  • Posts: 2049
  • TMA Member: Charter Member #65
Re: Ante-Chamber on a T/C Rifle.
« Reply #15 on: July 24, 2017, 09:47:58 PM »
It would certainly benefit from a polish job.
Logged
Hank in WV
TMA Charter Member #65, exp 4/30/2026
"Much of the social history of the western world over the past three decades has involved replacing what worked with what sounded good. . ." Thomas Sowell

Offline Ironhand

  • TMA Forum Member
  • ***
  • Posts: 242
  • TMA Member: Supporting Member # 664, Expiration 5/4/2019
Re: Ante-Chamber on a T/C Rifle.
« Reply #16 on: July 25, 2017, 08:46:24 AM »
You could use a ball mill to dish the face of the plug and then grind a scraper to the same radius.
It would get rid of the groove without shortening the plug and be much easier to keep clean.

IronHand
Logged
Place your clothes and your weapons where you can find them in the dark.

   Lazarus Long

Offline RobD

  • TMA Admin
  • ****
  • Posts: 3595
  • TMA President & Contributing Member
  • Location: NJ
Re: Ante-Chamber on a T/C Rifle.
« Reply #17 on: July 25, 2017, 04:25:05 PM »
yep, that's one option i had thought of since i have a 5/8" ball cutter for the lathe.  putting a radius to a brass scraper would be easy, too.
Logged
Pages: 1 [2]
« previous next »