Richard Miller .50 cal

[Second-rate Marksman]

This is a Richard Miller .50 cal that I stumbled upon on Gun Broker a few months ago. The seller wasn't asking much more for it than most guys are pricing their finished Kibler kits at.

[No Powder]

That's drop dead gorgeous. Do you use it or is it a gun for only display purposes?

[Second-rate Marksman]

I purchased this guy with every intention of shooting it. I took it out to a club shoot a couple months ago with the assumption that it was at least roughly sighted in—nope! I believe windage to be right on, but I appeared to be consistently low. The issue with filing down the front sight is that it also has that acid-etched finish, and it’s unlikely that I’ll be able to match the original finish after making alterations. Then again, what’s the point of having a rifle that you can’t (accurately) shoot?

[Winter Hawk]

How about the rear sight?  Can you drift it out and install a higher one, saving the original for if you ever decide to return it to the state you bought it in?

~Kees~

[Second-rate Marksman]

That's s a good idea! I should be able to drift the rear sight out and replace it with a higher one without any permanent modifications. Keeping the original sight for potential restoration down the road is definitely the way to go. Thanks for the suggestion; I'll look into getting a higher rear sight that fits.

[Winter Hawk]

You are quite welcome.  But now I've used up my quota of good ideas for the month.... 

~Kees~