Horn rehab project

[Bigsmoke]

I never put tape around the horn.  Does it really help?
That's a serious question.
Looks like you are working on the throat of the horn.  How far are you going to take it down?
Looks like a good project so far, not sure where you are going.
John
PS:  Are you going to take the tape off, or will it be there forever?

[KDubs]

I'll be taking the tape off sooner or later. 
 I'm following Sibley's book, pretty much just like the example shown in the book but without the split ring .
 The tape help me not bugger up the parts I don't want to bugger up.
 I'm rasping the throat down and paneling the spout.
 Guess I'll do a flat plug too.
  Also I will try dyeing the the throat/ spout and I'll be engraving a design based on my church Logo ,  Freedom Baptist
Kevin
 

[Bigsmoke]

Can't wait to see the finished product.

[KDubs]

 [ Invalid Attachment ]
 [ Invalid Attachment ]
 [ Invalid Attachment ]
 Well here she is, not a HC representation but my own take on one I guess.
 Simple dome base plug.
 Now on to the next one while I wait on a new pucking die for my BP production.
 Kevin

[Bigsmoke]

I was wondering about that horn the other day.
Looks pretty good to me.  Nice job.
I cannot remember ever doing a horn with engrailing on it.  Never had the time for that, considering I was always in a back order situation.  I don't think I ever missed anything by not doing it.
You might want to open up the spout hole a tad so the fiddle peg goes in deeper.  A tapered auger from Harbor Freight will give you a nice tapered spout hole.
John

[No Powder]

I like it Kevin.

[KDubs]

Ya know John I did use a tapered reamer but the outer hole was becoming much greater than the inner hole leaving a space around the peg.
 Thought I better stop there and was considering making a custom peg with the correct taper so as to completely fill the peg hole.
 The engrailing was done , gasp  , with a Dremel .
  [ Invalid Attachment ]
 This is the current horn I've moved on to.
 Sort of a tulip tip.
 We'll see how she turns out.
Kevin

[Bigsmoke]

You keep that up and you might get a job at October Country as a horn maker.