Your TMA Officers and Board of Directors
Support the TMA! ~ Traditional Muzzleloaders ~ The TMA is here for YOU!
For TMA related products, please check out the new TMA Store !

*** Folk Firearms Collective Videos ***



Changes are a'coming to the TMA website and forum. Please stay tuned!


« previous next »
Pages: [1]

Author Topic: Rifle Sling  (Read 3772 times)

Offline W. Welshman

  • TMA Forum Member
  • ***
  • Posts: 418
    • http://www.theweavingwelshman.com/home
  • TMA Member: 321
Rifle Sling
« on: July 09, 2008, 11:16:38 PM »
Would like to put a sling on this old JUKAR.Should I place a piece of leather under the middle ramrod barrel to hold the front of the sling and use a button stud on the back ?
Logged
Idaho North TMA State Representative

http://www.theweavingwelshman.com/home

Captchee

  • Guest
(No subject)
« Reply #1 on: July 10, 2008, 12:03:27 AM »
the only way it would hold is if the thimble is the type that screws  though the stock into the barrel ..
 If it comes through the stock  into the thimble  it  will eventually break the stock .
 The best way is to solder or dovetail a sling lug to the bottom of the barrel and them drill it so  that you can put a front sling swivel on it
Logged

Offline W. Welshman

  • TMA Forum Member
  • ***
  • Posts: 418
    • http://www.theweavingwelshman.com/home
  • TMA Member: 321
(No subject)
« Reply #2 on: July 10, 2008, 12:48:03 AM »
Thanks Captchee,I just found a barrel that had a piece solder on it.I'll drill the underlug and add a pin
Logged
Idaho North TMA State Representative

http://www.theweavingwelshman.com/home
Pages: [1]
« previous next »