Your TMA Officers and Board of Directors
Support the TMA! ~ Traditional Muzzleloaders ~ The TMA is here for YOU!
*** JOIN in on the TMA 2024 POSTAL MATCH *** it's FREE for ALL !

For TMA related products, please check out the new TMA Store !

The Flintlock Paper

*** Folk Firearms Collective Videos ***



« previous next »
Pages: [1]

Author Topic: Warped RamRod  (Read 415 times)

Offline 2 Locks

  • TMA Forum Member
  • ***
  • Posts: 147
    • http://www.MultiLakes.com
Warped RamRod
« on: June 27, 2010, 03:12:16 PM »
I don't mind a little warp in my ramrods, but one of the new spares I'm making looks like I used it for fishin' & hooked a 5 lb. Bass.  :shock:

I seem to remember a post here about straitening a ram rod.  Of course I can't find it now that I need it.  I think it was something about compressing the fibers on one side to release (or create) tension.

Can someone explain that technique again?
Thanks, Dave
Logged
Dave Leonard
Member #429 Expires 4/15/14

Offline david32cal

  • TMA Forum Member
  • ***
  • Posts: 421
(No subject)
« Reply #1 on: June 27, 2010, 03:30:03 PM »
try heating the bent area over a gas kitchen stove then hold it as straight as possible until it cools,i've staightend a few this way.
Logged
"The reason a dog has so many friends,He wags his tail instead of his tongue"

Offline mike rumping

  • TMA Forum Member
  • ***
  • Posts: 517
    • http://www.rumpingproductions.com/
(No subject)
« Reply #2 on: June 27, 2010, 05:45:08 PM »
you can do it by friction like straightin'  an arrow.
Logged
http://www.rumpingproductions.com/
TMA #226
Expires: 2/14/11
"Kentucke, situated on the fertile banks of the great Ohio,
rising from obscurity to shine with splendor, equal to any
other of the stars of the American hemisphere." ...... John Filson
Pages: [1]
« previous next »