Your TMA Officers and Board of Directors
Support the TMA! ~ Traditional Muzzleloaders ~ The TMA is here for YOU!
*** JOIN in on the TMA 2024 POSTAL MATCH *** it's FREE for ALL !

For TMA related products, please check out the new TMA Store !

The Flintlock Paper

*** Folk Firearms Collective Videos ***



Author Topic: Board bow  (Read 3391 times)

Offline Ironhand

  • TMA Forum Member
  • ***
  • Posts: 242
  • TMA Member: Supporting Member # 664, Expiration 5/4/2019
Board bow
« on: May 19, 2024, 08:55:35 AM »
Hi guys,  I decided to try making a board bow.  It went well and I have it tillered but I have a couple of problems. It's a 70 inch Red Oak stave,40lb @28 inches.

The first problem is that it has has developed a "C" shape as I worked it.
The second problem is that it's longer and lighter than I wanted.

My question is, can I shorten it p
Place your clothes and your weapons where you can find them in the dark.

   Lazarus Long

Offline Ironhand

  • TMA Forum Member
  • ***
  • Posts: 242
  • TMA Member: Supporting Member # 664, Expiration 5/4/2019
Re: Board bow
« Reply #1 on: May 19, 2024, 09:00:42 AM »
Stupid machine.

Can I shorten it to 66 or 68 inches at this point? It's tillered but not finished.

My hope is that this will remove some of the curve and perhaps raise the draw weight.

Thanks
Ironhand
Place your clothes and your weapons where you can find them in the dark.

   Lazarus Long

Offline Winter Hawk

  • TMA Contributing Member
  • ***
  • Posts: 2578
  • Location: Chauncey, OH
Re: Board bow
« Reply #2 on: May 19, 2024, 05:17:56 PM »
I would check with RobD, he is very knowledgeable about archery and its equipment.  And, without photos it never happened!   :bigsmile:
NMLRA Life
"All you need for happiness is a good gun, a good horse and a good wife." - D. Boone
USN June 1962-Nov. 65, USS Philip, DD-498

Dues paid to 02 Jan. 2025

Offline RobD

  • TMA Contributing Member
  • ***
  • Posts: 3599
  • TMA President
  • Location: NJ
Re: Board bow
« Reply #3 on: May 20, 2024, 05:45:57 AM »
Stupid machine.

Can I shorten it to 66 or 68 inches at this point? It's tillered but not finished.

My hope is that this will remove some of the curve and perhaps raise the draw weight.

Thanks
Ironhand

Yes and no.  If you shorten the stave, it will absolutely need re-tillering and that might negate the reason why it's been shortened.

Tillering a stave is an art of sorts, and it usually takes going through a number of staves/boards to learn the craft ... even so, all wood is different and sometimes it is what it is.

Offline Eric Krewson

  • TMA Forum Member
  • ***
  • Posts: 120
Re: Board bow
« Reply #4 on: July 30, 2024, 12:28:07 PM »
Don't know but I suspect you pulled it too far too soon while you were tillering it, most new guys do, myself included 28 years ago